Nissan Rogue: Wiring Harness Connector Corrosion (2008–2013)

What the evidence shows

Nissan recalled certain 2008-2013 Rogue (and 2014 Rogue Select) vehicles because a wiring harness connector can corrode from exposure to snow and road salt. This is documented in NHTSA campaign 15V032000, an official safety recall — not an owner complaint pattern or a manufacturer service bulletin.

What this means

Corrosion at the connector can cause an electrical short, increasing the risk of a fire.

What may be happening mechanically

Water containing road salt can work into the connector housing over repeated winters, corroding the terminals inside.

What owners may notice

• A burning smell or unexplained electrical malfunctions, especially after winter driving

What to check first

Watch for any burning smell or unexplained electrical faults, especially after winters in a salt-belt region, and confirm with a dealer whether campaign 15V032000 was completed for the specific VIN.

What this does not prove

A safety recall confirms an identified defect and a required remedy for the specific vehicles covered by NHTSA campaign 15V032000. It does not establish how many vehicles ever actually experienced the described failure, and any symptom listed above can have other causes — a qualified inspection is still the way to confirm the cause on a specific vehicle.

For owners and buyers

If you own or are considering a 2008–2013 Nissan Rogue, check the VIN against NHTSA campaign 15V032000 (through the manufacturer or the relevant national recall lookup) to see whether the remedy has already been completed. An open recall is normally repaired by the dealer at no cost to the owner.